Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 The NetBSD Foundation, Inc. All rights reserved. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 7.99.13 (GENERIC.201504280130Z) #0: Tue Apr 28 04:03:16 UTC 2015 builds@b46.netbsd.org:/home/builds/ab/HEAD/macppc/201504280130Z-obj/home/source/ab/HEAD/src/sys/arch/macppc/compile/GENERIC total memory = 320 MB avail memory = 295 MB timecounter: Timecounters tick every 10.000 msec macio: ff948658 pic: ff94d250 obio-base: 80000000 pic-base: 80040000 found openpic PIC at 80040000 OpenPIC Version 1.2: Supports 4 CPUs and 64 interrupt sources. bootpath: /pci@f2000000/mac-io@17/ata-4@1f000/disk@0:0/netbsd mainbus0 (root) cpu0 at mainbus0: 750 (Revision 2.5), ID 0 (primary) cpu0: HID0 0x8050c0a4, powersave: 1 cpu0: 500.00 MHz, 512KB WB L2 cache cpu0: WARNING: power management not supported memory0 at mainbus0: len=256 spd checksum failed, calc = 0x3b3, spd = 0x00 spdmem0 at memory0 spdmem0: SDRAM, no parity or ECC, 256MB, 133MHz (PC-133) spdmem0: 13 rows, 9 cols, 2 banks, 4 banks/chip, 7.5ns cycle time spdmem0: tAA-tRCD-tRP-tRAS: 3-20-20-45 spdmem0: voltage LvTTL (not 5V tolerant), refresh time 7.8us (self-refreshing) spdmem0: 0x00: 80 08 04 0d 09 02 40 00 01 75 54 00 82 10 00 01 spdmem0: 0x10: 8f 04 06 01 01 00 0e a0 60 00 00 14 0f 14 2d 20 spdmem0: 0x20: 15 08 15 08 00 00 00 00 00 00 00 00 00 00 00 00 spdmem0: 0x30: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 12 ba spdmem0: 0x40: ad ff ff ff ff ff ff ff 01 37 32 56 33 32 4d 36 spdmem0: 0x50: 33 36 42 54 36 2d 48 20 20 20 20 41 41 27 02 15 spdmem0: 0x60: 04 75 4f 00 00 00 00 00 00 00 00 00 00 00 00 00 spdmem0: 0x70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 64 cf memory0: WARNING: power management not supported uni_n0 at mainbus0 address 0xf8000000 ki2c0 at uni_n0 address 0xf8001000 iic1 at ki2c0: I2C bus ki2c0: WARNING: power management not supported uni_n0: WARNING: power management not supported uninorth0 at mainbus0 pci0 at uninorth0 bus 0 pci0: i/o space, memory space enabled pchb0 at pci0 dev 11 function 0 pchb0: Apple Computer Pangea AGP Interface (rev. 0x00) pchb0: WARNING: power management not supported r128fb0 at pci0 dev 16 function 0: ATI Technologies Rage Mobility M3 (AGP) (rev. 0x02) r128fb0: 64 MB aperture at 0x94000000 r128fb0: LVDS output is active, enabling backlight control wsdisplay0 at r128fb0 kbdmux 1: console (default, vt100 emulation) wsmux1: connecting to wsdisplay0 uninorth0: WARNING: power management not supported uninorth1 at mainbus0 pci1 at uninorth1 bus 0 pci1: i/o space, memory space enabled pchb1 at pci1 dev 11 function 0 pchb1: Apple Computer Pangea Host-PCI Bridge (rev. 0x00) pchb1: WARNING: power management not supported obio0 at pci1 dev 23 function 0: addr 0x80000000 zsc0 at obio0 irq 22,23 zstty0 at zsc0 channel 0 zstty0: WARNING: power management not supported zstty1 at zsc0 channel 1 zstty1: WARNING: power management not supported opic_establish_irq: setting IRQ 22 to priority 5 opic_establish_irq: setting IRQ 23 to priority 5 zsc0: WARNING: power management not supported snapper0 at obio0 offset 0x10000opic_establish_irq: setting IRQ 1 to priority 6 opic_establish_irq: setting IRQ 2 to priority 6 : irq 30,1,2 pmu0 at obio0 offset 0x16000 irq 47: opic_establish_irq: setting IRQ 47 to priority 5 rev. 12 pmu0: initializing RTC pmu0: initializing ADB nadb0 at pmu0: Apple Desktop Bus nadb0: WARNING: power management not supported pmu0: power-mgt not configured smartbat0 at pmu0 addr 0: smart battery flags: 5 AC present WARNING: Callback scheduled before sysmon task queue thread present WARNING: Callback scheduled before sysmon task queue thread present WARNING: Callback scheduled before sysmon task queue thread present smartbat0: WARNING: power management not supported pmu0: WARNING: power management not supported ki2c1 at obio0 iic2 at ki2c1: I2C bus deq0 at ki2c1 Apple Digital Equalizer, addr 0x68 deq0: WARNING: power management not supported ki2c1: WARNING: power management not supported wdc0 at obio0 offset 0x1f000 irq 19, level triggered: DMA transfer opic_establish_irq: setting IRQ 19 to priority 5 atabus0 at wdc0 channel 0 wdc0: WARNING: power management not supported wi0 at obio0 offset 0x30000 irq 57:opic_establish_irq: setting IRQ 57 to priority 5 802.11 address 00:30:65:13:be:63 wi0: using Lucent Embedded WaveLAN/IEEE wi0: Lucent Firmware: Station (8.70.1) wi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps obio0: WARNING: power management not supported snapper0: codec: TAS3001 audio0 at snapper0: full duplex, playback, capture opic_establish_irq: setting IRQ 58 to priority 6 ohci0 at pci1 dev 24 function 0: Apple Computer Pangea USB Controller (rev. 0x00) opic_establish_irq: setting IRQ 27 to priority 6 ohci0: interrupting at irq 27 ohci0: OHCI version 1.0 usb0 at ohci0: USB revision 1.0 usb0: WARNING: power management not supported ohci1 at pci1 dev 25 function 0: Apple Computer Pangea USB Controller (rev. 0x00) opic_establish_irq: setting IRQ 28 to priority 6 ohci1: interrupting at irq 28 ohci1: OHCI version 1.0 usb1 at ohci1: USB revision 1.0 usb1: WARNING: power management not supported uninorth1: WARNING: power management not supported uninorth2 at mainbus0 pci2 at uninorth2 bus 0 pci2: i/o space, memory space enabled pchb2 at pci2 dev 11 function 0 pchb2: Apple Computer Pangea Host-PCI Bridge (rev. 0x00) pchb2: WARNING: power management not supported fwohci0 at pci2 dev 14 function 0: Apple Computer Pangea Firewire (rev. 0x00) opic_establish_irq: setting IRQ 40 to priority 5 fwohci0: interrupting at irq 40 fwohci0: OHCI version 1.0 (ROM=0) fwohci0: No. of Isochronous channels is 8. fwohci0: EUI64 00:03:93:ff:fe:3d:86:7e fwohci0: Phy 1394a available S400, 1 ports. fwohci0: Link S400, max_rec 2048 bytes. ieee1394if0 at fwohci0: IEEE1394 bus fwip0 at ieee1394if0: IP over IEEE1394 fwohci0: Initiate bus reset gem0 at pci2 dev 15 function 0: Apple Computer GMAC Ethernet (rev. 0x00) opic_establish_irq: setting IRQ 41 to priority 5 gem0: interrupting at irq 41 bmtphy0 at gem0 phy 0: BCM5221 10/100 media interface, rev. 3 bmtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto gem0: Ethernet address 00:03:93:3d:86:7e, 10KB RX fifo, 4KB TX fifo uninorth2: WARNING: power management not supported mainbus0: WARNING: power management not supported vmmask 67180000 schedmask 7ff80000 highmask 7ff80000 timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0 timecounter: Timecounter "mftb" frequency 16640000 Hz quality 100 fwohci0: BUS reset fwohci0: node_id=0xc800ffc0, gen=2, CYCLEMASTER mode ieee1394if0: 1 nodes, maxhop <= 0 cable IRM irm(0) (me) ieee1394if0: bus manager 0 uhub0 at usb0: Apple Computer OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered uhub1 at usb1: Apple Computer OHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub1: 2 ports with 2 removable, self powered atapibus0 at atabus0: 2 targets cd0 at atapibus0 drive 1: cdrom removable swwdog: unable to attach cfdriver WARNING: module error: builtin module `swwdog' failed to init, error 17 cd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2 (Ultra/33) wd0 at atabus0 drive 0 wd0: wd0: drive supports 16-sector PIO transfers, LBA addressing wd0: 9590 MB, 19485 cyl, 16 head, 63 sec, 512 bytes/sect x 19640880 sectors adbkbd0 at nadb0 addr 2: PowerBook G3 keyboard (Japanese layout) wskbd0 at adbkbd0 mux 1 wskbd0: connecting to wsdisplay0 wsmouse0 at adbkbd0 mux 0 adbkbd0: WARNING: power management not supported adbms0 at nadb0 addr 3: EMP trackpad 2-button, 400 dpi wsmouse1 at adbms0 mux 0 adbms0: WARNING: power management not supported adbbt0 at nadb0 addr 7: button device adbbt0: WARNING: power management not supported wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66) wd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66) (using DMA) cd0(wdc0:0:1): using PIO mode 4, DMA mode 2, Ultra-DMA mode 2 (Ultra/33) (using DMA) Kernelized RAIDframe activated swwdog0: software watchdog initialized Searching for RAID components... AC Power: AC adapter online. boot device: wd0 root device (default wd0a): dump device (default wd0b): file system (default generic): root on wd0a dumps on wd0b root file system type: ffs kern.module.path=/stand/macppc/7.99.13/modules init path (default /sbin/init): init: trying /sbin/init smartbat0: normal capacity on 'Battery charge state'