Orion1 CPU = Low Orion1 CPU = Low === KURO U-Boot. === ** LOADER ** ** KUROBOX BOARD: KURO_BOX LE (CFG_ENV_ADDR=fffff000) U-Boot 1.1.1 (Apr 10 2007 - 18:10:08) Marvell version: 1.12.1 - TINY DRAM CS[0] base 0x00000000 size 128MB DRAM Total size 128MB [256kB@fffc0000] Flash: 256 kB Addresses 20M - 0M are saved for the U-Boot usage. Mem malloc Initialization (20M - 16M): Done NAND: 256 MB Soc: 88F5182 A2 CPU: ARM926 (Rev 0) running @ 500Mhz Orion 1 streaming disabled SysClock = 250Mhz , TClock = 166Mhz USB 0: host mode USB 1: host mode PCI 0: PCI Express Root Complex Interface PCI 1: Conventional PCI, speed = 33000000 Net: egiga0 [PRIME] Using 88E1118 phy Found boot image hit any key to switch tftp boot. Hit any key to stop autoboot: 0 <> Hit any key to stop autoboot: 0 Reset IDE: Marvell Serial ATA Adapter Integrated Sata device found Device 0: OK Model: FB080C4080 Firm: HPF0 Ser#: 5RW22931 Type: Hard Disk Supports 48-bit addressing Capacity: 76319.0 MB = 74.5 GB (156301488 x 512) Using device ide0, partition 4 Loading from block device ide device 0, partition 4: Name: hda4 Type: U-Boot File:/netbsd-arm.bin 5061572 bytes read ## Starting application at 0x00008000 ... NetBSD/evbarm (orion_nas) booting ... Loaded initial symtab at 0xc04395d0, strtab at 0xc04764c8, # entries 15505 pmap_postinit: Allocated 35 static L1 descriptor tables Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008 The NetBSD Foundation, Inc. All rights reserved. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 5.99.01 (KUROBOX_PRO) #0: Mon May 4 17:24:44 JST 2009 root@t-105.i.ki.nu:/export/src/sys/arch/evbarm/compile/obj/KUROBOX_PRO total memory = 128 MB avail memory = 119 MB mainbus0 (root) cpu0 at mainbus0: ARM926EJ-S rev 0 (ARM9EJ-S core) cpu0: DC enabled IC enabled WB enabled EABT branch prediction enabled cpu0: 32KB/32B 1-way Instruction cache cpu0: 32KB/32B 1-way write-back-locking-C Data cache orion0 at mainbus0: Marvell MV88F5182 SoC Rev. A0 Orion1 orion0: CPU Clock 400.000 MHz SysClock 200.000 MHz TClock 166.664 MHz oriontmr0 at orion0 addr 0xf1020300-0xf10203ff: Marvell Orion Timer oriongpp0 at orion0 addr 0xf1010100-0xf10101ff: Marvell Orion General Purpose I/O Port Interface oriongpp0: Data Out: 0x00000000 oriongpp0: Data Out Enable Control: 0xfc01000d oriongpp0: Data Blink Enable: 0x00000000 oriongpp0: Data In Polarity: 0x00000000 oriongpp0: Data In: 0x00000005 oriongpp0: Data Interrupt Cause: 0x00000008 oriongpp0: Data Interrupt Mask: 0x00000000 oriongpp0: Data Interrupt Level Mask: 0x00000000 com0 at orion0 addr 0xf1012000-0xf101201f irq 3: ns16550a, working fifo com0: console com1 at orion0 addr 0xf1012100-0xf101211f irq 4: ns16550a, working fifo mvsata0 at orion0 addr 0xf1080000-0xf1087fff irq 29: Marvell Serial-ATA Host Controller (SATAHC) mvsata0: GenIIe, 1hc, 2port/hc atabus0 at mvsata0 channel 0 atabus1 at mvsata0 channel 1 ehci0 at orion0 addr 0xf1050000-0xf1051fff irq 17: Marvell Orion USB 2.0 Interface usb0 at ehci0: USB revision 2.0 ehci1 at orion0 addr 0xf10a0000-0xf10a1fff irq 12: Marvell Orion USB 2.0 Interface usb1 at ehci1: USB revision 2.0 orionpex0 at orion0 addr 0xf1040000-0xf1041fff irq 11: Marvell Orion PCI Express Interface pci0 at orionpex0 Marvell 88F5182 SoC Orion1 (miscellaneous memory, revision 0x02) at pci0 dev 0 function 0 not configured oriongbe0 at orion0 addr 0xf1072000-0xf1073fff: Marvell Orion Gigabit Ethernet Controller oriongbe0: Ethernet address 00:16:01:a4:cc:e9 makphy0 at oriongbe0 phy 8: Marvell 88E1116 Gigabit PHY, rev. 1 makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto orioncesa0 at orion0 addr 0xf1090000-0xf109ffff irq 28: Marvell Orion Cryptographic Engines and Security Accelerator oriontwsi0 at orion0 addr 0xf1011000-0xf101101f irq 5: Orion TWSI controller iic0 at oriontwsi0: I2C bus rs5c372rtc0 at iic0 addr 0x32: RICOH RS5C372[AB] Real-time Clock orionidmac0 at orion0 addr 0xf1060800-0xf1060bff: Marvell Orion IDMA Controller/XOR Engine uhub0 at usb0: vendor 0x0000 EHCI root hub, class 9/0, rev 2.00/1.00, addr 1 uhub1 at usb1: vendor 0x0000 EHCI root hub, class 9/0, rev 2.00/1.00, addr 1 mvsata0 port 0: device present, speed: 1.5Gb/s wd0 at atabus0 drive 0: wd0: 76319 MB, 155061 cyl, 16 head, 63 sec, 512 bytes/sect x 156301488 sectors raidattach: Asked for 8 units Kernelized RAIDframe activated Searching for RAID components... boot device: root device: wd0a dump device (default wd0b): file system (default generic): root on wd0a dumps on wd0b mountroot: trying lfs... mountroot: trying ffs... root file system type: ffs init path (default /sbin/init): init: copying out path `/sbin/init' 11 Wed May 6 14:08:29 GMT 2009 swapctl: adding /dev/wd0b as swap device at priority 0 Starting file system checks: /dev/rwd0a: file system is clean; not checking /dev/rwd0e: file system is clean; not checking /dev/rwd0f: file system is clean; not checking /dev/rwd0g: file system is clean; not checking Setting tty flags. Setting sysctl variables: Starting network. Hostname: kuroarm.i.ki.nu NIS domainname: hoge-fuga-foo-bar IPv6 mode: host Configuring network interfaces: oriongbe0. Adding interface aliases:. add net default: gateway 192.168.1.1 Building databases: dev, utmp, utmpx done Starting syslogd. Checking for core dump... Starting rpcbind. Starting ypbind. Mounting all filesystems... Clearing temporary files. Starting amd. Creating a.out runtime link editor directory cache. Checking quotas: done. Setting securelevel: kern.securelevel: 0 -> 1 Starting virecover. Starting local daemons:. Updating motd. Starting ntpd. Starting sshd. Starting inetd. Starting cron. Wed May 6 23:08:44 JST 2009 NetBSD/evbarm (kuroarm.i.ki.nu) (console) login: root Password: May 6 23:38:33 kuroarm login: ROOT LOGIN (root) ON console Last login: Wed May 6 23:07:16 2009 on console Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008 The NetBSD Foundation, Inc. All rights reserved. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 5.99.01 (KUROBOX_PRO) #0: Mon May 4 17:24:44 JST 2009 Welcome to NetBSD! 20090504 5.99.01 installed (128MB/80GB) You have new mail. Terminal type is vt100. We recommend creating a non-root account and using su(1) for root access. kuroarm#