>b st(0) Boot: st(0,0,0) >> NetBSD tapeboot [$Revision: 1.1.1.1 $] 517288+289004+52612+[43740+41018]=0xe6632 Starting program at 0x4000 console is ttya Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 1.2E (RAMDISK) #2: Fri May 23 17:11:35 PDT 1997 jeremy@mobeius:/usr/home/netbsd/src/sys/arch/sun3x/compile/RAMDISK Model: Sun 3/80 (hostid 42004380) fpu: mc68882 real mem = 16777216 avail mem = 14508032 using 115 buffers containing 942080 bytes of memory mainbus0 (root) obio0 at mainbus0 memerr0 at obio0 addr 0x61001000 ipl 7: (Parity memory) intreg0 at obio0 addr 0x61001400 zsc0 at obio0 addr 0x62000000 ipl 6: (softpri 3) kbd0 at zsc0 channel 0 ms0 at zsc0 channel 1 zsc1 at obio0 addr 0x62002000 ipl 6: (softpri 3) zstty0 at zsc1 channel 0 (console) zstty1 at zsc1 channel 1 zsc1: enabling zs interrupts eeprom0 at obio0 addr 0x64000000 idprom0 at obio0 addr 0x640007d8 clock0 at obio0 addr 0x640007f8 ipl 5 iommu0 at obio0 addr 0x60000000: range 16MB le0 at obio0 addr 0x65002000 ipl 3: address 08:00:20:07:8a:17 le0: 8 receive buffers, 2 transmit buffers esp0 at obio0 addr 0x66000000 ipl 2: ESP100, 20MHz, SCSI ID 7 scsibus0 at esp0: 8 targets sd0 at scsibus0 targ 0 lun 0: SCSI2 0/direct fixed sd0: 163MB, 2337 cyl, 2 head, 71 sec, 512 bytes/sec sd1 at scsibus0 targ 3 lun 0: SCSI2 0/direct fixed sd1: 411MB, 1476 cyl, 9 head, 63 sec, 512 bytes/sec st0 at scsibus0 targ 4 lun 0: SCSI1 1/sequential removable st0: density code 0x0, 512-byte blocks, write-protected fdc0 at obio0 addr 0x6e000000 ipl 6 vect 0x40: (softpri 2) chip 82072 obmem0 at mainbus0 bwtwo0 at obmem0 addr 0x50400000 ipl 4 (1152x900) enabling interrupts fixed, 512 blocksboot device: WARNING: clock gained 68 days -- CHECK AND RESET THE DATE! WARNING: no swap space found Welcome to the NetBSD/sun3x RAMDISK root! This environment is designed to do only three things: 1: Partititon your disk (use the command: edlabel /dev/rsd0c) 2: Copy a miniroot image into the swap partition (/dev/rsd0b) 3: Reboot (using the swap partition, i.e. /dev/sd?b). Copying the miniroot can be done several ways, allowing the source of the miniroot image to be on any of these: boot tape, NFS server, TFTP server, rsh server The easiest is loading from tape, which is done as follows: mt -f /dev/nrst0 rewind mt -f /dev/nrst0 fsf 2 dd bs=32k if=/dev/nrst0 of=/dev/rsd0b (For help with other methods, please see the install notes.) To reboot using the swap partition, first use "halt", then at the PROM monitor prompt use a command like: b sd(,,1) -s To view this message again, type: cat /.welcome ssh: